Active Unanswered
Welcome
Moderators: Don Ayers, Al Benton, Don Vogt
Re: Welcome
What length? Have you checked with the Mariner's Museum?
Bill Hammond
1960 36' Connie
Flint/Port Huron, MI
http://www.chris-craft.org/registry/vie ... at_id=1708
1960 36' Connie
Flint/Port Huron, MI
http://www.chris-craft.org/registry/vie ... at_id=1708
Re: Welcome
Have you tried the Mariners Museum? They did not have the diagram for my exact Connie but they had one for about 10 boats later.drginseng wrote:I'm looking for a wiring diagram for my '62 Connie.
http://www.marinersmuseum.org/library/chris-craft
Troy in ANE - Former President CCABC
1957 CC 21' Continental "Yorktown" (Mom's boat)
https://www.chris-craft.org/boats/22625/
1985 Formula 242LS "Gottago"
1991 Formula 36PC "Band Aids"
Life Is Too Short To Own An Ugly Boat
1957 CC 21' Continental "Yorktown" (Mom's boat)
https://www.chris-craft.org/boats/22625/
1985 Formula 242LS "Gottago"
1991 Formula 36PC "Band Aids"
Life Is Too Short To Own An Ugly Boat
Re: Welcome
Or perhaps a year or two earlier. I would think the length of the boat is more critical than the exact year. And one or two engines maybe.
Bill Hammond
1960 36' Connie
Flint/Port Huron, MI
http://www.chris-craft.org/registry/vie ... at_id=1708
1960 36' Connie
Flint/Port Huron, MI
http://www.chris-craft.org/registry/vie ... at_id=1708
Re: Welcome
Bill,
I refer to it as a 37' because, like yours, the hull card shows 36'-11". Odd that they come out 7", 10 & 11". Wouldn't the blueprints call for the frame to be the same? Why would they vary by up to almost a foot?
I'm looking for the PCV fitting that goes in the base of the carb, attaching to the copper piper and into the intake if you know anyone that has one. It was strange when I bought it the port engine had a big hose in its place. I figured the threads got stripped and that was the fix. There was vacuum restriction. One day I find the copper tubing with flare nuts and the threads are fine. They must've dropped it so I've looked for the fitting figuring someone didn't make an effort to get it after dropping it. I need a small monkey for a first mate.
I refer to it as a 37' because, like yours, the hull card shows 36'-11". Odd that they come out 7", 10 & 11". Wouldn't the blueprints call for the frame to be the same? Why would they vary by up to almost a foot?
I'm looking for the PCV fitting that goes in the base of the carb, attaching to the copper piper and into the intake if you know anyone that has one. It was strange when I bought it the port engine had a big hose in its place. I figured the threads got stripped and that was the fix. There was vacuum restriction. One day I find the copper tubing with flare nuts and the threads are fine. They must've dropped it so I've looked for the fitting figuring someone didn't make an effort to get it after dropping it. I need a small monkey for a first mate.
Who is online
Users browsing this forum: No registered users and 4 guests