Active Unanswered
Deck rails/hardware for '67 Cavalier
Moderators: Don Ayers, Al Benton, Don Vogt
- ballardMike
- Posts: 16
- Joined: Sat Jan 26, 2013 3:07 pm
- Location: seattle
- Contact:
Deck rails/hardware for '67 Cavalier
Other than buying some stock and milling it myself to repair/replace a couple of rear deck rails - anybody have an option or resource or done this already??
I have two router bits that approximate the top/lower radius but it's not quite right.
Thanks!
'67 Cavalier Futura 33'
- ballardMike
- Posts: 16
- Joined: Sat Jan 26, 2013 3:07 pm
- Location: seattle
- Contact:
Re: Deck rails/hardware for '67 Cavalier
ah well... nobody eh? i ended up making three new pieces.
'67 Cavalier Futura 33'
-
- Posts: 697
- Joined: Sun Mar 18, 2012 10:27 am
- Contact:
Re: Deck rails/hardware for '67 Cavalier
Just saw this, but keep in mind that the shapers that CC would have been using were purty large.... hence the larger bits.
I am going through the same thing making some fairly large quarter round in teak and/or mahogany...... so I have actually been looking for a 3 hp 220V shaper.
I am going through the same thing making some fairly large quarter round in teak and/or mahogany...... so I have actually been looking for a 3 hp 220V shaper.
Who is online
Users browsing this forum: No registered users and 2 guests