Active Unanswered
Adjusting Zenith carb
Moderators: Don Ayers, Al Benton
-
- Posts: 26
- Joined: Tue May 14, 2019 3:55 pm
- Contact:
Adjusting Zenith carb
How do you set carburetor with just the low speed adjustment? This pertains to a Zenith on a 6 cylinder Hercules engine
-
- Posts: 2
- Joined: Sat Feb 22, 2020 9:54 am
- Contact:
Re: Adjusting Zenith carb
Your high speed adjustment is done through the float level. A good rule of thumb that I have used is to pull the bowl, with the carb upside down and level adjust your float height so that it is slightly higher than a horizontal plane. This is done by gently bending the stop tab. My WB’s run about perfect like that. The low speed adjustment is done with the screw.
Who is online
Users browsing this forum: No registered users and 4 guests