I have a mould for the Silver Arrow Engine cover and cowlings, This mould was professionally made from the engine cover and cowlings of my 59 silver arrow with the "283".(had it made for the missing cover on My 58 silver arrow)If any member of the CCABC needs this for their restoration I will lend it to you (NO CHARGE) except for shipping both ways.Cover is located in Western NY state (Buffalo).
Al Damiani
[email protected]
Active 
UnansweredSilver Arrow Parts/Moulds
Moderators: Don Vogt, Al Benton, Don Ayers
-
Al Damiani
- Posts: 7
- Joined: Mon Nov 14, 2005 1:01 pm
- Location: BUFFALO NY
- Contact:
hole in engine cover.
al,
My SA engine cover has a round vent hole in top above the carburetor and is covered by a bolt on Aluminum vent. The previous owner must have had some reason for doing this and I am not certain if or how I could correct it.
Do you know of any reason this could have been done? The engine is a 312 Interceptor with what looks like a Carter 4V with a flame arrestor on top.
If I wanted to do away with the hole in the f/g engine cover (a 5 in circle) how would I do that.javascript:emoticon(':?:')
Thanks,
John
My SA engine cover has a round vent hole in top above the carburetor and is covered by a bolt on Aluminum vent. The previous owner must have had some reason for doing this and I am not certain if or how I could correct it.
Do you know of any reason this could have been done? The engine is a 312 Interceptor with what looks like a Carter 4V with a flame arrestor on top.
If I wanted to do away with the hole in the f/g engine cover (a 5 in circle) how would I do that.javascript:emoticon(':?:')
Thanks,
John
-
Al Damiani
- Posts: 7
- Joined: Mon Nov 14, 2005 1:01 pm
- Location: BUFFALO NY
- Contact:
Who is online
Users browsing this forum: No registered users and 0 guests