Keeping your powerboat under power is a lot easier with good advice. Post your power systems questions here.
3 posts • Page 1 of 1
I'm having difficulty reassembling throttle rod and parts below gearbox. Maybe a part or two are missing. Picture attached. I have identified the three parts I have as A, B and C. I believe part B is supposed to be used to vary the friction on throttle rod so it won't rotate as the wheel is turned. With only the three parts I have I'm stumped. Can someone offer advice? I believe gearbox is a post war Gemmer.
You do not have the required permissions to view the files attached to this post.
C was originally spot welded to the backside of A. Part be is missing the small bolt that pulls it together. You should see 2 small holes on the arms. The round part of C fits into the round part of B. The missing bolt adjusts the tension to hold the throttle lever in position. The throttle rod goes through the small hole in A and you tighten the screw on A to clamp it to the rod.
You cleared up my confusion by telling me that part C was originally spot welded to part A. Now it makes sense. I have the small machine screw that adjusts part B arm tension. Good explanation. Thank you much.
Users browsing this forum: No registered users and 6 guests