Active Active   Unanswered Unanswered

283 carb settings

Keeping your powerboat under power is a lot easier with good advice. Post your power systems questions here.

Moderators: Al Benton, Don Ayers, Don Vogt

rjtipple
Posts: 5
Joined: Sat Feb 09, 2013 10:13 am
Contact:

283 carb settings

Post by rjtipple » Mon Sep 09, 2019 7:24 am

I have a '63 Sea Skiff with a completely rebuilt 283. I need to find out the initial settings for the carb. It idles at about 500 rpm when cold, but doesn't make much power as the rpm's rise. I haven't been able to get the boat to get up on a plane. It seems to bog down as I try to accelerate. Any advice will be appreciated.

User avatar
Bilge Rat
Posts: 306
Joined: Thu Jul 16, 2015 4:02 pm
Contact:

Re: 283 carb settings

Post by Bilge Rat » Mon Sep 09, 2019 7:47 am

Some ideas:

Verify that the distributor advance is working. You'll need a timing light with advance knob to accurately check this. In lieu of that, take the distributor cap off and twist the rotor, it should spring back indicating the advance springs are working. The whole springs and weights assembly can get rusty and stick.

Recheck the firing order.

Try a replacement ignition coil.

Are you running standard breaker point ignition or Pertronix electronic?

A blockage of the high speed jets in the carb might be causing this, anything over idle would switch to the high speed jets.

Although it's been rebuilt, a quick compression check might show a loss of power on some cylinders.

Can it rev up and stay at high RPM in neutral okay?
1966 Lyman Cruisette 25 foot "Serenity Now!"
1953 Chris Craft Sportsman 22 foot "Summerwind"

Post Reply

Who is online

Users browsing this forum: No registered users and 4 guests