Active Active   Unanswered Unanswered

Deck rails/hardware for '67 Cavalier

This is a focused discussion area for information unique to Chris-Craft's Cavalier Division.

Moderators: Don Ayers, Don Vogt, Al Benton

Post Reply
User avatar
ballardMike
Posts: 16
Joined: Sat Jan 26, 2013 3:07 pm
Location: seattle

Deck rails/hardware for '67 Cavalier

Post by ballardMike » Mon Feb 25, 2013 9:36 pm

:?:
Other than buying some stock and milling it myself to repair/replace a couple of rear deck rails - anybody have an option or resource or done this already??

I have two router bits that approximate the top/lower radius but it's not quite right.

Thanks!
'67 Cavalier Futura 33'

User avatar
ballardMike
Posts: 16
Joined: Sat Jan 26, 2013 3:07 pm
Location: seattle

Re: Deck rails/hardware for '67 Cavalier

Post by ballardMike » Mon Jun 17, 2013 7:34 pm

ah well... nobody eh? i ended up making three new pieces.
'67 Cavalier Futura 33'

Peter M Jardine
Posts: 697
Joined: Sun Mar 18, 2012 10:27 am

Re: Deck rails/hardware for '67 Cavalier

Post by Peter M Jardine » Fri Jun 21, 2013 10:13 pm

Just saw this, but keep in mind that the shapers that CC would have been using were purty large.... hence the larger bits.
I am going through the same thing making some fairly large quarter round in teak and/or mahogany...... so I have actually been looking for a 3 hp 220V shaper.

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests