My strut is #2583
Does any one know the angle of this strut.
I measured it as 15.6 degrees ( tan = 6-1/8 / 27-1/8 ) using a laser level. The center line of the shaft being 6-1/8 inches above the strut base and the laser projected center line being 27-1/8 " down the table.
I would appreciate conformation.
Thanks
Active Unanswered
Strut angle
Moderators: Don Ayers, Al Benton, Don Vogt
- parroteyes
- Posts: 333
- Joined: Tue Jul 18, 2006 8:06 pm
- Location: Ohio
- Contact:
Strut angle
Hull # 16-R-OX2 (March 1946)
Engine 1B #26564
That's me 1950 - already a CC lover!
Engine 1B #26564
That's me 1950 - already a CC lover!
Re: Strut angle
On my '56 Continental, the liturature says it is a 15 degree strut. I am not sure if yours is the same, but I would bet it is. I am sure they had some standard design principals and 15 seems pretty 'standard'.
Steve A
1956 18' Chris-Craft Continental
1956 18' Chris-Craft Continental
Who is online
Users browsing this forum: No registered users and 8 guests