Active Active   Unanswered Unanswered

Initial HF-7 ATF fill

Keeping your powerboat under power is a lot easier with good advice. Post your power systems questions here.

Moderators: Al Benton, Don Ayers, Don Vogt

Post Reply
Posts: 4
Joined: Mon Sep 26, 2016 8:10 pm

Initial HF-7 ATF fill

Post by kelpy » Wed Sep 12, 2018 11:23 am

After 53 years, the original 327 in my Cutlass finally rotted out and has been replaced with a 350 short block and is about to be lifted back into the boat. How much ATF should the direct drive HF-7 Paragon gear take as a starting point. One quart? Two quarts? Ill adjust the level after the engine runs for a while.

Post Reply

Who is online

Users browsing this forum: No registered users and 6 guests