Active Active   Unanswered Unanswered

temp sending unit

Your old Chris-Craft electrical system can be a challenge. If it runs on "juice" pose your questions and offer your advice here.

Moderators: Don Ayers, Don Vogt, Al Benton

fozbuzz
Posts: 58
Joined: Fri Jan 11, 2008 4:50 pm
Contact:

temp sending unit

Post by fozbuzz » Fri Dec 05, 2014 9:15 am

Wanna add a temp gauge on my '59 Sportsman K motor--got gauge, need sending unit--will GM 12v work? Threaded hole in R front of head--would this port work for sending unit? Thanks, Foz
58chris1.jpg
You do not have the required permissions to view the files attached to this post.

farupp
Posts: 832
Joined: Sat Oct 29, 2005 6:25 am
Location: Charleston, SC
Contact:

Re: temp sending unit

Post by farupp » Fri Dec 05, 2014 12:34 pm

I would think it would work if your electrical system is 12 volt.
Frank Rupp
1959 22-foot Sea Skiff Ranger
283 Flywheel Forward engine

User avatar
drrot
Posts: 1936
Joined: Mon Nov 14, 2005 12:28 pm
Location: Three Lakes, WI
Contact:

Re: temp sending unit

Post by drrot » Sat Dec 06, 2014 8:28 am

I'd send the gauge to Dale at www.ccgauges.com and have him match them. Best way to make it work right.
Jim Staib
www.finewoodboats.com


1947 Penn Yan 12' Cartopper WXH474611
1950 Chris-Craft 22' Sportsman U-22-1532
1957 Chris-Craft 26' Sea Skiff SK-26-515
1968 Century 17' Resorter FG-68-174

fozbuzz
Posts: 58
Joined: Fri Jan 11, 2008 4:50 pm
Contact:

Re: temp sending unit

Post by fozbuzz » Sat Dec 06, 2014 9:46 am

Thanks, Jim--was gonna try that before installing!

Post Reply

Who is online

Users browsing this forum: No registered users and 5 guests