Page 1 of 1

Deck rails/hardware for '67 Cavalier

Posted: Mon Feb 25, 2013 9:36 pm
by ballardMike
:?:
Other than buying some stock and milling it myself to repair/replace a couple of rear deck rails - anybody have an option or resource or done this already??

I have two router bits that approximate the top/lower radius but it's not quite right.

Thanks!

Re: Deck rails/hardware for '67 Cavalier

Posted: Mon Jun 17, 2013 7:34 pm
by ballardMike
ah well... nobody eh? i ended up making three new pieces.

Re: Deck rails/hardware for '67 Cavalier

Posted: Fri Jun 21, 2013 10:13 pm
by Peter M Jardine
Just saw this, but keep in mind that the shapers that CC would have been using were purty large.... hence the larger bits.
I am going through the same thing making some fairly large quarter round in teak and/or mahogany...... so I have actually been looking for a 3 hp 220V shaper.