Hi all
just about finished restoring my 1956 21ft capri. have wheel, horn ring but no part of the switch mechanism. A source for these goodies will be very much appreciated. It is mid fifties chrysler type exactly as on page 319 of don danenbergs book thank you!

Howard It sounds do-able but oh so frightening!!!
Thanks for the reply

Hi all
about to stain blonde area on a 21 ft capri. The area of concern is the transom. Is the white stripe portion carved into the transom or simply painted on? If it is recessed, any advice would be greatly appreciated. Thanks

To all responders, Thanks very much. Was toying with the hammer and chisel method and also a router and jig method. Leaning toward router and jig method with practice on plywood first. Planning on making a groove in 1/2" plywood (jig) the right width for the frame and using a 1/2" x 1/2" mortising b...

Just installed new deck on 21' 1956 capri. Would greatly appreciate some advice on routing the groove for the windshield. 3/8" inboard and tapering to 1/8" outboard. hate to mess it up now
Connie

Hi Greg we are on the exact same thought process. will have the aft deck beams completed by noonish today and will then start on hatches. will have to determine soon if one hatch or two. I am looking for a deck vent that is on my original drawing for a Cadillac engine (#1218) That would keep it look...

I am totally rebuilding 1956 cc capri 21 ft Now working new deck beams, hatches and deck. This boat was built with 2 hatches, rather than 1 big one. Would like to add wedges under the two one barrel carburetors to increase efficiency of carbs. The problem is I have a height problem under the hatches...

would like to install flapper valves in dual exhausts for chrysler m45 -2.5" ID. Looking for supplier that might have these items pre made that could be fastened in line inside the transom of course. Restoring 21 ft capri and would be much easier to install now before deck and hatch work can begin T...

Thanks for prompt reply. Any thoughts on proper hold down technique?

blueprint calls for 31 gal tank. what material is correct or acceptable to build new tank. also correct hold down straps and mounting protocol. Help please

Looking for info on availability on exhaust manifolds for chrysler v8 model M45S. new castings or rebuilt. Thank you for all help in advance. Keith

Engines offered were 3 WR or 3 WBR. What are these engines, cubic inch and make? Thank you.

Looking for a piece of mahogany 9 1/2" x 5" x 18". Would prefer one solid piece rather than laminating. Hardwood suppliers in our area cannot get one. For my 1956 Capri restoration.