Active Unanswered
Adjusting Type M Clutch
Moderators: Don Ayers, Al Benton, Don Vogt
-
- Posts: 61
- Joined: Tue Jan 25, 2011 8:02 am
- Contact:
Adjusting Type M Clutch
Last fall when I changed the oil in the engine and the trans I used Brad Penn straight 30W oil. This spring I noticed some slippage in the trans at higher rpm's so I took the trans cover off to adjust the clutch. Unfortunately, I can't get a good wrench fit on the adjusting and lock nuts and don't want to use the "hammer and chisel" method. Any ideas?
-
- Posts: 61
- Joined: Tue Jan 25, 2011 8:02 am
- Contact:
Re: Adjusting Type M Clutch
I use the hammer and brass punch method if stuck. Try to loosen it first. My punch is made from an old propeller shaft.
Jim Staib
www.finewoodboats.com
1947 Penn Yan 12' Cartopper WXH474611
1950 Chris-Craft 22' Sportsman U-22-1532
1957 Chris-Craft 26' Sea Skiff SK-26-515
1968 Century 17' Resorter FG-68-174
www.finewoodboats.com
1947 Penn Yan 12' Cartopper WXH474611
1950 Chris-Craft 22' Sportsman U-22-1532
1957 Chris-Craft 26' Sea Skiff SK-26-515
1968 Century 17' Resorter FG-68-174
Who is online
Users browsing this forum: No registered users and 10 guests