Active Active   Unanswered Unanswered

Distributor IGW-4149A Parts

Your old Chris-Craft electrical system can be a challenge. If it runs on "juice" pose your questions and offer your advice here.

Moderators: Don Ayers, Al Benton, Don Vogt

les
Posts: 4
Joined: Wed Sep 22, 2021 1:13 pm
Contact:

Distributor IGW-4149A Parts

Post by les » Wed Jan 26, 2022 9:02 am

I am replacing tune up parts in a IGW-4149A distributor. I am unable to find the the insulating bushing and washers that insulate the primary wire stud that goes through the base. Are these parts sourced or is there a DIY procedure?

les
Posts: 4
Joined: Wed Sep 22, 2021 1:13 pm
Contact:

Re: Distributor IGW-4149A Parts

Post by les » Sat Jan 29, 2022 5:52 pm

I was able to use a flanged nylon bushing and nylon washer from hardware. To insulate the points spring strip, I cut a strip from a poly bottle and drilled a hole at one end.

Post Reply

Who is online

Users browsing this forum: No registered users and 8 guests