Deck rails/hardware for '67 Cavalier

[ballardMike]

Other than buying some stock and milling it myself to repair/replace a couple of rear deck rails - anybody have an option or resource or done this already??

I have two router bits that approximate the top/lower radius but it's not quite right.

Thanks!

[ballardMike]

ah well... nobody eh? i ended up making three new pieces.

[Peter M Jardine]

Just saw this, but keep in mind that the shapers that CC would have been using were purty large.... hence the larger bits.
I am going through the same thing making some fairly large quarter round in teak and/or mahogany...... so I have actually been looking for a 3 hp 220V shaper.